What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 18.06.2025 23:52

but I think this circuit , shows a few more pieces.
It seems Mohan does not understand the difference between a comment and an Answer.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
There are two important concepts here.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Justin Bieber talks 'anger issues,' says he's 'broken' in emotional Instagram post - ABC News
So, the voltage could go up to 500 volts, and the fuse will not open up.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
A fuse is a non-resetable over current circuit protector.
Edit 2024–10.
This is where this question deviates from being a 'generic' question, and becomes more specific.
It also is a device that limits the change in current flow.
Prescription risk: Meds that could cause dementia - WFMZ.com
This is where the MOV conducts again, and dissipated the energy.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
(Dc diagram shown, AC is similar).
How do you know when someone really loves you?
what exactly is a ‘surge’ protector?
These devices are installed between the “hot” and “neutral” and protective ground.
He then describes Rainy Season and Lightning.
What would you change in Rings of Power?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
nine
The other is “what does a “fuse” do?”
Defense Department signs OpenAI for $200 million 'frontier AI' pilot project - theregister.com
The MOV will conduct when the voltage exceeds 50% of line voltage.
An AC voltage/ current source, and an ac inductive load.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Thunder-Pacers: Jalen Williams scores 40 as OKC wins Game 5 of NBA finals - Al Jazeera
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
At least they know the answer if they wanted it.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
I want to have anal sex, but my wife refuses. What do I do?
Now when you have a certain ac resistance, then a current flows in a loop.
eight
At one ohm, the resistor has a maximum of 1 watt power.
Why didn’t Obito confront Kakashi after he witnessed him kill Rin?
What is lightning?
First Sentence:
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
DC-area pediatrician on CDC urging summer camp operators to screen for measles immunity - WTOP
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Because the load is inductive, the current lags the voltage.(by a bit).
Trump’s Truth Social files with SEC for bitcoin-ether ETF - The Block
[image of Common-mode choke]
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Here is a simplified AC power diagram.
The third is lightning and “how it gets conducted into a home.”
but this device (an Inductor) … impedes the rapid changes in the current.
But it can get overloaded, and no longer works.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, what happens?
One
There are three different concepts here that are getting confused.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The bolt then partially travels down the line to your home.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
For this case there are devices called Metal oxide varistors (MOV).
A circuit breaker is similar, but is resettable.
One is “what exactly is in a ‘surge protector’ ? ”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–10[John johnson John Johnson ]
Barnstars:
This device then solves the entire problem.
I post the exact comment here.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What does a fuse do?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Upvotes:
This one hit behind the barn.
2024–10–16 [ OO OLAOYE OYEBODE ]
He then describes the function of a fuse.
a photo is worth a thousand words.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
He then asserts :
This is 'the assistant's answer'
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
These are simplified answers to the original question, and does not change anything I wrote above.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
the problem then depends on "how fast does the fuse operate?".
In schematic diagrams this is the symbol for a fuse:
[old diagram got deleted by accident]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.